Re: Wireless clients cannot connect to wired server in same VSC

Hello,

If you are struggling to get the server into the virtual network segment where the clients live you could:

1. Trunk (like a dot1q trunk not a Procurve trk) the tagged VLAN out of the LAN port of the Controller and do some further testing / packet tracing.
2. Break the clients out of the VSC locally by egressing them onto a tagged VLAN out of the back of each AP.
3. Buy a MSM AP with wired Eth ports on it and bind the port into the controlled VSC - thinking about it -  I don't think these are 1GbE so may be of limited use with a server unless it is a very light load.

I hope that gives you a few ideas - I don't like seeing posts with no replies.

Let us know how you get on.

thanks

Ian